Jet-Tronics 3/2WAY PNEUMATIC VALVE

Artikelinformation

This valve is attached directly to the receiver to control undercarriages with single acting cylinders and wheel brakes with proportional function(PWM). (Pre selected mode: brake function)

It replaces the mechanical valve AND the servo plus linkage:

-The bottom measurements without connections are smaller than those of usual mechanical valves (L=28mm, B=16mm) in which the room is dropped for servo and linkage. The height is 29mm.

-The connections consist of high-quality metal fast connections for tubes with 3mm of outside diameter.

-The speed of delivering in and out of the undercarriage can be throttled. This happens by using restrictors which are attached at output 3.

-In the off condition the valves is closed. When operating, the open position is indicated by a LED.

-The remember function prevents that the undercarriage unintentionally works, if the transmitter function should be in an other position as on shutdown.

-The current consumption of 10mA at 5volts is by 50% lower than at the usual 1watt valves.

-The air throughput is around 40% higher and therefor very well suitable also for big undercarriages.

-Viton sealings make the valves insensitive toward most oil sorts and is therefor and because of the higher throughput usable as smoker valve also.

-In the brake function, the minimun brake point can be adjustable to the 10% point of the travel of the transmitters function. A second brake point can be adjustable to the 90% point of the travel of the trasmitters function. This might be nearly full brake. This takes care, that the pulse modulated brake function starts working at 10% and ends by 90% of the travel of the transmitter function. From 0-10% the valve is closed, from 90-100% travel the valve is fully open, which prevents air loss on full brake.

Technical data

• Supply voltage: 3.5V..7.5V
• Current consumption: 100mA bei 5V
• Pressure range: 0-10 Bar
• Measurements: 28x16x28mm (L/B/H)
• Weight: 23gr