COCKPIT KIT for Ka 6E 1:3

ИНФОРМАЦИЯ О НАИМЕНОВАНИЯХ

We usually say that what distinguishes a beautiful RC glider from a very beautiful RC glider is the layout of the cabin ...

We offer you the possibility of transforming the interior of your Ka 6E ECOTOP by TOPMODEL using this scale cockpit kit that we have concocted lovingly for you ;-)

With a minimum of time, patience and good taste, turn your favorite machine into a great realistic sailplane!

The parts that constitute the seat support

Then, these once glued

Note the 2 flat hinges that allow the articulation of the seat and thus, to be able to access underneath to put there the receiver battery packs or the receiver

The molded fiberglass parts of the seat are cut and glued on their support

The parts constituting the dummy formers numbered from #1 to #5 (the #5 being closest to the nose) and the inside of the sides of the fuselage

All these parts are then assembled with CA as above ...

... before being put in place in the fuselage. The internal sides abut against the main fuselage former

In the bottom of the dummy formers, you notice that we cut out growths with a hole in the middle for the passage of the pull-pull rudder cables like the full size glider. Here we have instead routed the control linkage of the towing hook

The final result after painting and gluing the sticker of the dashboard and safety labels

And of course, the addition of some "homemade" details like the control column and spring trim, the airbrake control, the release handle and the COM microphone

Do not hesitate to add the 33% safety harnesses available under  #049104A

The dashboard panel is attached as on the real size one, by a screw on each side that pass through the eyelet cut on the last dummy former

Note that we have "planted" small screws that simulate the fixation screws of the flying instruments to perfect the realism

Just remains to install a beautiful pilot doll in this sumptuous cockpit

Good flights!